Download Free Nutanix NCS-Core Real Exam Questions Download
Latest Nutanix NCS-Core Real Exam Dumps PDF
NEW QUESTION 92
Refer to the exhibit.
After performing ESXi to AHV conversion on a cluster, the alerts shown in the exhibit display on Prism. What should the administrator do to resolve this issue efficiently?
- A. Remove VMs from the Protection Domain and add them back in.
- B. Remove the VMs. create a new Protection Domain, and add VMs to it
- C. Create a new Protection Domain and add the VMs to rt.
- D. Delete the Protection Domain, create a new Protection Domain, and add the VMs to it
Answer: A
NEW QUESTION 93
A consultant is using a customer's switch for installation. Although the 10GbE ports for each of the hosts are connected to the switch, the nodes fail to be discovered.
What is causing the issue?
- A. IPMI port is not plugged in.
- B. 10GbE ports are configured with the incorrect duplex setting.
- C. Foundation VM is running on a Windows host.
- D. IPv6 is not enabled on the switch.
Answer: D
NEW QUESTION 94
A company needs to replicate their VMs to a remote site and must have an RPO of less than 1 hour.
When creating a protection domain, what should an administrator do to meet this requirement?
- A. Enable Async Replication with an RPO of 60 minutes
- B. Enable Entity Sync on the designated VMs
- C. Enable Availability Zones and send the VM to multiple targets
- D. Enable Near-Sync Replication with an RPO of 15 minutes
Answer: A
Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v5_10:sto-pd-guidel
NEW QUESTION 95
Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.
Which policy should be used to meet this requirement?
- A. An Application Security Policy
- B. A Whitehst-Based Policy
- C. AnIsolation Environment Policy
- D. A Quarantine Policy
Answer: C
Explanation:
NEW QUESTION 96
A consultant creates a Nutanix cluster using the 10.10.10.0/24 network and VLAN 10. The customer creates a VM network inside the Prism using VLAN 20. The customer starts to create VMs but is unable to ping the default gateway from these new systems.
What is causing the issue?
- A. The CVM/hypervisor cannot use the same VLAN as guest VMs.
- B. The switch port is not set up as a trunk.
- C. Only one VLAN is supported on AHV.
- D. The CVM/hypervisor must be on an untagged VLAN.
Answer: B
NEW QUESTION 97
A consultant creates three storage containers (container-1, container-2, container-3). The customer requires that only container-1, which will be utilized as an NFS datastore, be presented to external hosts.
However, users are able to mount all three containers.
What is causing this problem?
- A. Compression was turned on for all containers.
- B. A Container-level whitelist entry was configured.
- C. Deduplication was turned on for all containers.
- D. A Global whitelist entry was configured.
Answer: D
NEW QUESTION 98
In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.
The current schedule configuration is as follows:
* Repeat every 6 hours
* Local Retention Policy 1
* Remote Retention Policy 8
* Starting time 12 am
At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection.
Which strategy should the administrator use to meet these requirements?
- A. From the local site, restore the VM from the local snapshot by selecting the correct snapshot.
- B. From the local site, retrieve the correct remote snapshot, then restore the VM locally.
- C. From the Remote site, restore the VM from the local snapshot by selecting the correct snapshot
- D. From the Remote site, activate the Protection Domain, then re-protect the entity.
Answer: B
NEW QUESTION 99
Anadministrator needs to evaluate if the existing configuration of Protection Domains meets the specified corporate recovery policy for SQL Data. The corporate policy requires that all SQL Servers be recoverable at the DR site within 30 minutes, and must result in a maximum of 60 minutes of data loss. SQL data must be required.
The protection domain is configured as follows:
* Application consistent snapshots are enabled
* The SQL server VMs are assigned to the Protection Domain as their own Consistency Group
* The Protection Domain schedule is configured as snapshots taken every 90 minutes from 7 am until 8 pm What must be changed to meet the required policy?
- A. Revise the schedule to be 45 minutes
- B. Revise the schedule to be 30 minutes
- C. Revise the schedule to be 60 minutes
- D. Revise the schedule tc be 15 minutes
Answer: C
NEW QUESTION 100
A customer has the following requirement for a Nutanix cluster:
* Must support high-performance Nutanix Volumes iSCSI workloads
* Must utilize AHV nodes
* Must use 10 GbE interface
How should the customer optimize networking?
- A. Convert Cluster to ESXi and enable Jumbo Frame on Host and CVM
- B. Enable Jumbo Frame on just the Host
- C. Enable Jumbo Frames on just the CVM
- D. Enable the use of Jumbo Frame on Host and CVM
Answer: B
NEW QUESTION 101
An administrator learns that some security settings in a cluster have been changed. The environment is out ofcompliance with required policies.
Which function should be used to revert any settings that have changed from the defaults and prevent further violations?
- A. Defense Information Systems Agency STIG enforcement
- B. Security Configuration Management Automation (SCMA)
- C. Cluster Lockdown with strong password enforcement
- D. Advanced Intrusion Detection Environment (AIDE)
Answer: B
Explanation:
Explanation
Ref:http://myvirtualcloud.net/nutanix-scma-the-security-feature-that-could-save-your-organization/
NEW QUESTION 102
An administrator needs to forecast infrastructure requirements for a new program and its associated applications. Prior to the projected start of the new program, all existing applications will be decommissioned.
How should the administrator perform this task?
- A. Add up the recovered workloads and manually remove from the Runway configuration.
- B. Check the Disregard Existing Workloads radio button in the Runway scenario.
- C. Power down the workloads during a maintenance window and run the Capacity Runway.
- D. Check the Disregard Existing Nodes radio button in the Runway scenario.
Answer: B
NEW QUESTION 103
What is the minimum number of nodes required for a Nutanix Cluster to support Replication Factor 3 (RF3) on a storage container?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 104
A consultant finishes creating a new ESXi cluster. The consultant connects to the nodes via laptop and a personal flat switch. The host/CVM network is on VLAN 23. The customer has the native VLAN on the ToR switches set to 23.
The customer wants to use LACP. Before placing the nodes on the customer network, the consultant tags VLAN 23 for each host and CVM. The consultant connects the nodes to the customer network and finds that they are unreachable.
What is causing this issue?
- A. The host and CVM are incorrectly configured.
- B. Under the vSwitch0 settings, the consultant did not select Route based on IP hash.
- C. The customer has LACP fallback enabled on switch ports.
- D. The hosts have not been migrated to a vSphere Distributed Switch.
Answer: D
NEW QUESTION 105
During a technical call with a customer, it is identified that this installation will be software only on Dell servers. The out-of-band management interfaces will not be given IP addresses until the consultant is onsite.
Which Foundation method should be used for this type of installation?
- A. Bare metal using node serial numbers.
- B. Bare metal using block serial numbers.
- C. Bare metal using iDRAC MAC addresses.
- D. Bare metal using LAN MAC addresses.
Answer: C
NEW QUESTION 106
An administrator needs to initiate a new VDI project within a couple of months. Prism Central reports there are no storage resources to accommodate such workloads.
The administrator sees many powered-off VMs and has the authority to delete test VMs powered off at least for 30 days. Test VMs belong to the Test category.
Using Prism Central, which steps are required to identify the correct VMs tobe deleted?
- A. Create a new Scenario selecting Test VMs. filter by uptime
- B. Filter VMs list, choose Test category and Inactive under Efficiency
- C. Use Capacity Runway to filter by Test and Powered-off VMs
- D. Create a new Project selecting Test VMs,sorting by power state
Answer: B
Explanation:
NEW QUESTION 107
A customer has a G6 AHV cluster with 4x10GbE NICs on each node and the following configuration:
* Networking is set to default
* Only two NICs are connected
The customer receives the following critical message:
The NIC is disconnected from the switch, or the switchport is failing.
What should the consultant verify to resolve the issue?
- A. The other two 10GbE connections are removed from the default bond.
- B. The NICs are connected for balance-slb.
- C. The VLANs are configured correctly on the switch or tagged on the cluster.
- D. The NICs are configured for active-backup.
Answer: D
NEW QUESTION 108
......
PDF (New 2022) Actual Nutanix NCS-Core Exam Questions: https://gocertify.actual4labs.com/Nutanix/NCS-Core-actual-exam-dumps.html