2024 Updated Verified D-PE-OE-23 dumps Q&As - 100% Pass Guaranteed
Provide Valid Dumps To Help You Prepare For Dell PowerEdge Operate 2023 Exam
NEW QUESTION # 10
A technician needs to initially configure a server from a bare metal condition in the following areas:
- Processor settings
- Disk configuration
- iDRAC network settings
The technician can only reboot once to achieve these tasks.
Where should the technician configure these settings? (Choose three.)
- A. iDRAC Settings
- B. System BIOS
- C. Device Settings
- D. PXE Settings
- E. PERC Configuration Utility
Answer: B,D,E
NEW QUESTION # 11
Which mobile devices are supported by Quick Sync in 13G Dell EMC PowerEdge servers?
- A. iOS devices only
- B. iOS, Android, and Windows Phone devices
- C. Android devices only
- D. iOS and Android devices only
Answer: C
NEW QUESTION # 12
On a PowerEdge R640 server, the System Lockdown mode has been enabled. Certain features are no longer available in the System BIOS utility or IDRAC GUI.
Which other feature is no longer available?
- A. Booting to a 32-bit OS
- B. Lifecycle Controller
- C. OMSA
- D. iSM
Answer: B
NEW QUESTION # 13
Which tool allows an administrator to remotely back up a PowerEdge server configuration to streamline server deployments?
- A. Virtual console
- B. OME
- C. OMSA
- D. iDRAC
Answer: D
NEW QUESTION # 14
Which card connects to the PCI bus, is physically smaller than a on the system board of a Dell EMC PowerEdge 14G server?
- A. NDC
- B. FPGA
- C. PCIe
- D. OCP
Answer: C
NEW QUESTION # 15
An engineer must install a new GPU card in a Dell PowerEdge 15G server. They discover the server has two 570W PSU, but the new configuration requires 900W of power. More powerful PSUs are ordered.
What can be done for the system to support the GPU card before replacing the PSUs?
- A. Change the redundancy configuration to 2+0.
- B. Enable Power Capping and set a limit of 150%.
- C. Disable Power Capping and remove any limit.
Answer: A
NEW QUESTION # 16
A technician wants to move memory from a few older system into a newer system.
What is the most efficient method for the technician to accomplish this task?
- A. Power down any of the older servers to move any memory to the new server, update BIOS to allow mis-matched memory.
- B. Use iDRAC to view the memory details of the older systems. Power down the servers to move matching memory to the new server
- C. Back up the server profile on the older server, move the matching memory, and import the server profile to the new server
- D. Power down all of the older servers to physically check the memory. Move any matching memory to the new server.
Answer: A
NEW QUESTION # 17
A technician wants to configure the iDRAC on a new server using the iDRAC Quick Sync 2 feature.
What is required to use this feature?
- A. Quick Sync enabled bezel
- B. iDRAC Enterprise license
- C. OpenManage Mobile App installed on an Android or iOS device
- D. OpenManage Mobile App installed on a laptop
Answer: C
NEW QUESTION # 18
Which iDRAC menu includes the detailed log files required to troubleshoot a hardware issue on a Dell EMC PowerEdge server?
- A. Maintenance
- B. Troubleshooting
- C. Diagnostics
- D. System
Answer: A
NEW QUESTION # 19
A Dell EMC PowerEdge server logs the following CPU Machine Check error: CPU1 IERR.
What action might be required to solve the alert?
- A. Clear logs
- B. Reseat the IDSDM
- C. Swap the PERC controller
- D. Update the Intel driver
Answer: D
NEW QUESTION # 20
Case Study 4
A company is experiencing a noticeable decrease in performance when accessing data on their Dell EMC Isilon cluster. The cluster hosts Microsoft Windows home directories and general purpose file shares. In addition, a file pool policy moves data that has not been modified in six months to an achieve tier.
The administrator wants your assistance in understanding the reason for the slow data access. The number of users accessing the cluster has not changed. The administrator has shared the following baseline metrics. The outputs were captured from a performance- acceptable time frame.
Trace route shows:
- 3 hops between clients and the cluster
- Average latency is 3 ms
Iperf shows:
- 940 Mb/s average bandwidth
- 005 ms average jitter
Netstat on the local network shows:
- 05% average re-transmission rate
Hostcache list:
- 20 ms average roundtrip time across all clients
The administrator shows you the details of the hostcahce.list output. The output indicates that the top clients on the list have an average of 242 ms round trip time.
Based on the output, what information should be provided to the administrator?
- A. An increase in the average round trip time indicates a network problem.
- B. Recalculate and re-populate round trip times by using isi_cbind clear command.
- C. An average round trip time less than 300 ms is in the acceptable range.
- D. Only the aggregate of all average round trip times will indicate an issue.
Answer: D
NEW QUESTION # 21
A user installed OpenManage Essentials (OME) on a Dell EMC PowerEdge R640 server. OME has discovered, and is currently monitoring, another 30 remote PowerEdge 14G servers.
Each server has the following configuration:
- 2x CPUs
- 384 GB RAM
- 6x 1TB drives in a RAID 6 virtual disk
- No hot spare drive
- PERC
- vFlash
- iDRAC9
- Express license
At 9 PM on Monday evening, one of the remote servers has a disk failure but stays operational. The administrator monitoring OME does not find out about the issue until 5 PM Friday. They place a support call to investigate why OME was not informed about the disk failure before that time.
What is the reason for this issue not being reported to OME?
- A. Remote servers are not configured with OME as the trap destination address. OME discovered the issue during a routine status check which is configured to run at 5 PM every Friday.
- B. Remote servers are not configured with OME as the trap destination address. OME was informed of the issue when remote servers sent alerts at 5 PM Friday.
- C. Remote servers need to have the iDRAC Enterprise license installed to be able to send alerts.
- D. OME only updates its alert database at 5 PM every Friday.
Answer: A
NEW QUESTION # 22
What must be done before upgrading OMSA from the 32-bit to the 64-bit version?
- A. Disable UAC
- B. Back up the configuration
- C. Uninstall the earlier version
- D. Save the license file
Answer: C
NEW QUESTION # 23
A technician needs to configure a server to allow the OS to manipulate processor frequencies for higher power efficiency.
Which setting can they enable to achieve this?
- A. Performance per Watt (DAPC)
- B. Performance per Watt (OS)
- C. Adjacent Cache Line Prefetch
- D. Logical Processing
Answer: B
NEW QUESTION # 24
A server needs to be configured with a six disk RAID 10 using 3 TB drives.
What should be the available array size in this configuration?
- A. 6TB
- B. 4TB
- C. 9TB
- D. 12TB
Answer: C
NEW QUESTION # 25
......
Achieve Success in Actual D-PE-OE-23 Exam D-PE-OE-23 Exam Dumps: https://gocertify.actual4labs.com/EMC/D-PE-OE-23-actual-exam-dumps.html